Table of Contents
Advertisement
Installation
Installation items
The factory only provides the heat pump unit; the other items that are mentioned in the
illustration are to be provided by the user or installer.
Attention!
○ All feeding of chemicals to the pool water has to be done downstream of the heat
pump.
○ Install a bypass when the flow of the pool pump is more than 20% above the rated flow
of the heat exchanger of the heat pump.
○ Install the heat pump on a solid foundation and use the damping rubbers to eliminate
vibrations and noise.
○ Always keep the unit straight up. If the unit has been tilted or put on his side, allow
24h before starting the unit.
○ The unit may be installed virtually anywhere outdoors. For indoor pools please consult
your supplier.
Location
The unit may be installed virtually anywhere outdoors. For indoor pools please consult
your supplier.
DO NOT put the unit in an enclosed area with a limited air volume where the unit
discharge air will be re-circulated.
DO NOT put the unit next to shrubs, which can block the air inlet. Such locations deny
a continuous source of fresh air, which reduces its efficiency and may prevent adequate
heat delivery.
The picture below give the minimum required distances from each side of the heat
pump.
Install the heat pump where you have the best access
to warm air during the swimming season
6
Advertisement
Table of Contents
