Table of Contents
Advertisement
43-1130.fm Page 9 Tuesday, May 30, 2000 1:22 PM
7. Lift the base's antenna to a vertical posi-
tion.
On a Wall Plate or Wall
1. Insert the bracket's tabs into the base's
lower tab slots, then press down on the
bracket's clips and insert them into the
clip slots.
2. Plug one end of the supplied short mod-
ular cord into the
TEL LINE
back of the base.
3. Insert the supplied AC adapter's barrel
plug into the
DC IN 9V
the base.
4. Route the adapter and modular cords
through the grooves on the bracket.
5. Plug the modular cord's other end into
the wall plate jack, then align the
bracket's keyhole slots with the wall
plate studs and slide the base down-
ward to secure it.
6. Plug the adapter into a standard AC out-
let.
jack on the
Note: To mount the TAD directly on a wall,
you need two screws (not supplied) with
heads that fit into the keyhole slots on the
jack on the back of
bottom of the base.
Follow the steps under "On a Wall Plate or
Wall," then apply these additional instruc-
tions for placement on a wall.
Installation
7. Press and lift out the handset holder, flip
it over, then snap it back into place so it
holds the handset.
8. Lift the base's antenna to a vertical posi-
tion.
1. Drill
two
holes
inches (100 mm) apart.
Then thread a screw into
each
hole,
letting
heads extend about
inch (8 mm) from the wall.
2. Plug one end of the sup-
plied long modular cord
into the
jack at the back of the
TEL LINE
base.
3. Align the bracket's keyhole slots with the
mounting screws and slide the base
downward to secure it.
15
3
/
16
/
"
5
16
the
3
15
/
"
5
/
16
16
9
Advertisement
Table of Contents
