Placing The Base On Adesk Top - Radio Shack ET-919 Owner's Manual

43-1089.fm Page 7 Tuesday, August 17, 1999 3:24 PM
PLACING THE BASE ON A
DESK TOP
Follow these steps when you place the
base on a desk, shelf, or table.
1. Remove the bracket by holding in
both tabs and gently pulling out the
wide end of the bracket.
2. Plug one end of the supplied long
modular cord into the phone jack on
the back of the base.
3. Insert the supplied AC adapter's
barrel plug into the
the back of the base.
4. Route the adapter's cord through
5. Insert the tabs on the narrow end of
jack on
DC 12V
6. Plug the modular cord's other end
the strain relief slot on the bottom of
the base.
the bracket into the lower slots on
the bottom of the base and push the
tabs on the wide end of the bracket
into the upper slots on the bottom of
the base.
into a modular phone line jack.
Strain
Relief
Slot
7