Notes About The Hmi030 And Flex Interface Connection - ABB Tmax T7 Operating Instructions Manual

Device Characteristics
MM030
AD030 DO 8 digital outputs
AD030 AO 4 analog outputs
mixed inputs: 2 ana-
AD030 MI
log and 2 digital
HMI030 Display

4.10.1. Notes about the HMI030 and Flex Interface connection

Protection release connection to the HMI030 or Flex Interface units must be made with corded shielded two-wire cable (e.g.
BELDEN 3105A) no more than 15 m in length. The shield must be earthed on both the circuit-breaker and unit sides.
4.11. Ekip Connect
Ekip Connect is a software application for personal computers equipped with the Microsoft Windows® operating system, which
allows data to be exchanged with one or more ABB low voltage devices.
Ekip Connect can be connected to ABB low voltage circuit-breakers equipped with electronic protection release for the purpose of:
- Putting the CB into service.
- Monitoring the state of all the available signals.
- Reading information (alarms, measurements, parameters).
- Changing the configuration parameters, especially for protection releases without display.
- Executing commands.
- Identifying faults in the protection release and communication network.
- Performing tests.
Operating tests in switchboards are facilitated since the parameters and test reports can be saved.
Ekip Connect is free of charge and is either supplied on an installation CD or can be obtained from the Internet address http://
bol.it.abb.com in the section "Work Tools - Software for moulded case and air circuit-breakers".
B0431
Model
Description
Controls exchanges of information between the protection release
and accessories of the Flex Interface family
Receives information from MM03 and operates its digital outputs
as a consequence
Receives information from MM03 and operates its analog outputs
as a consequence
Repeats the digital inputs following a request from the MM03
Displays the data received
from the protection release
or MM030
B1751
Notes
note 1: after having been configu-
red in the appropriate way, it can be
connected to the protection release
or straight to MM030
note 2: the HMI030 can be connected to MM030 from
MM030 software releases 2.0 onwards
Apparatus
Emax X1-Tmax T7-Tmax T8
1SDH000587R0002
Doc. No
Reference
documentation
1SDH000622R0001
1SDH000672R0001
1SDH000672R0001
1SDH000672R0001
1SDH000573R0001
Scale
Page No
65/66