Introduction - King Quest PRO VQ4800 Owner's Manual

1

INTRODUCTION

Thank you for purchasing a KING antenna!
The KING Quest Pro is specifically designed to work with the DIRECTV 101 satellite for SD
programming and nationwide distant network local channels found on the 101 satellite. Other local
area channels are broadcast from either the 101 or 119 satellites via spot beam transponders and
have limited availability outside your immediate local area. If your local channels are broadcast from
the 119 satellite, an optional universal controller KING #UC1000 (sold separately - see page 13)
is required which allows the antenna to automatically switch between the 101 and 119 satellites to
receive those channels.
LEGACY RECEIVERS
The KING Quest Pro is compatible with a variety of DIRECTV legacy receivers including Models D10,
D11, D12, H20, H21, H22, H23, H24, HR20, HR21, HR22, HR23 and HR24.
The connection diagram on page 4 shows how to use your KING Quest Pro with the included Power
Inserter to receive programming from satellite 101.
To find out more about the KING UC1000 controller which allows you to receive programming from
satellite 119 as well as the 101, contact KING or your local dealer.
SWM-ONLY RECEIVERS
SWM-only receivers such as H25 and higher models are only compatible with the 101 satellite and
require additional SWM hardware which is sold separately (see page 6).
NOTE: The KING Quest Pro may be used as a portable satellite antenna or as a roof-mounted antenna (see section 7
for roof installation instructions).
Unbox your KING Quest Pro and verify all components are present.
Page 2