Advertisement
Leveling & Height Adjustment
1. The official F.I.G. height spec. is 280 cm ± 5 mm. This measurement is taken from the floor to
the inside bottom of the ring, Figure C.
2. Place a carpenters level through the rings & hang a weight from the centre to stretch cables.
3. Pull cable as required through the wire cable clamps until desired height & level is achieved,
you may have to slacken wire rope clips. When the desired height is achieved, tighten the lower
clamp nuts securely (figure B-1) and the 2 upper clamps firmly but not completely on both
cables.
4. Carefully apply an initial load to the cable & alternately and uniformly retighten all the nuts
securely.
5. Inspect and periodically retighten the clamps.
Note: Never reposition the cable clamps on the cable after they have been fastened tightly to
cable, or serious injury due to cable failure is possible.
108 - Ceiling Hung Rings Instructions Rev1 8920071
5
4/
Advertisement
