Swivel Attachment To Beam Clamps - SA Sport 108 Ceiling Hung Rings Manual

Swivel Attachment to Beam Clamps

1. Remove the bolts, washer, Cotter pin & Castle Nut from the underside of the Beam Clamps
2. Insert the top rounded end of the swivel between the two hanger brackets on the underside of
the beam Clamp.
3. Replace the bolt, washers, and castle nut as per figure A. Tighten securely using ¾"
wrenches.
4. Insert the cotter pin thru the castle nut and spread the Cotter Pin open to prevent the castle nut
from coming undone.
5. Install one of the Thimbles on the end of the swivel (figure B).
6. Repeat steps 2 to 5 for the second swivel.
7. Proceed to 'Cable Attachment to Swivel'.
Note: It is suggested to determine the required length of cable and strip the plastic off the
steel cable prior to installing the cable to the swivels. Don't shorten the cables until you
finish the installation, at which time the excess can be cut off.
108 - Ceiling Hung Rings Instructions Rev1 8920071
5
2/