Resetting To The Factory Setting; Memory Dialing; Storing A Number In Memory; Entering A Pause - Radio Shack 900 MHz Digital Spread Spectrum CordlessTelephone Owner's Manual

Resetting to the Factory Setting

To restore a service dial button to its factory
default, lift the handset and press
then press the service dial button you want to
reset. The handset sounds a long beep.

MEMORY DIALING

The phone can store up to 10 numbers you
can dial by entering a memory location num-
ber (0–9).

Storing a Number in Memory

Note: A series of beeps sounds and the
phone exits the storing process if you wait
more than 20 seconds between each key
press.
1. Lift the handset.
2. Press . The TALK/LOW BATT indi-
MEM
cator blinks.
3. Enter the number and any tone mode
changes or pause entries. (See "Enter-
ing a Pause".)
Notes:
• Each number you store can be up to
20 digits long.
• If you try to enter more than 20 digits,
the phone sounds a series of beeps
and exits the storing process. Start
over from Step 2.
• Each tone or pause entry uses one
digit of memory.
4. Press , then enter the memory loca-
MEM
tion number (0–9).
Note: You can also use any of the spe-
cial service buttons (
,
WAY CALL CANCEL CW
) as the memory locations.
DIAL
5. For each stored number, write the con-
twice
MEM
To replace a stored number, simply store a
new one in its place.
To delete a stored number, lift the handset
and press
location number (0–9) you want to clear. The
handset sounds a long beep to signal that
the memory location is clear.

Entering a Pause

In some telephone systems, you must dial an
access code (9, for example) and wait for a
second dial tone before you can dial an out-
side number. You can store the access code
with the phone number. However, you
should also store a pause after the access
code to allow the outside line time to con-
nect. To enter a 2-second pause, press
PAUSE
PAUSE

Dialing a Memory Number

To dial a number stored in a standard memo-
ry location, press
dial tone, press
location number for the number you want to
dial.
Note: If you select an invalid or empty mem-
ory location, the phone sounds a series of
beeps. Press
cation number again.
If you have stored a number in any of the
special service buttons, simply press that
,
RETURN CALL 3-
button without pressing
, or
REPEAT
tomatically goes off-hook and dials the num-
ber in about two seconds.
Operation
The handset sounds a long beep to indi-
cate that the number is stored.
tact's name next to the appropriate loca-
tion number on the supplied memory
directory sticker. Peel the backing off the
sticker and attach it to the phone.
twice, then enter the memory
MEM
. For a longer pause, press
additional times.
. When you hear a
TALK
and enter the memory
MEM
and enter the memory lo-
MEM
TALK
RDL/
RDL/
. The phone au-
13