Radio Shack 900 MHz Digital Spread Spectrum Dual Keypad Cordless Telephone with Caller ID/Call Waiting ID Owner's Manual page 8

43-5520.fm Page 8 Friday, July 21, 2000 8:01 AM
• Always connect the AC adapter to the
phone before you connect it to AC
power. When you finish, disconnect the
adapter from AC power before you dis-
connect it from the phone.
Note: Your telephone connects directly to a
modular telephone line jack. If your phone
line jack is not a modular jack, you can up-
date the wiring yourself, using jacks and
adapters available at your local RadioShack
store. Or, you can let the phone company up-
date the wiring for you.
The USOC number of the jack to be installed
is RJ11C (RJ11W for a wall plate).
On a Desk Top, Shelf, or Table
1. Plug one end of the supplied long modu-
lar cord into the
TEL LINE
back of the base.
2. Plug the modular cord's other end into a
modular telephone line jack.
3. Insert the supplied AC adapter's barrel
plug into the DC IN 9V
of the base.
4. Route the adapter's cord through the
strain relief slot on the bottom of the
base.
5. Plug the adapter into a standard AC out-
let.
6. Lift the base's antenna to a vertical posi-
tion.
On a Wall Plate or Wall
1. Insert the two tabs at the top of the nar-
row end of the supplied bracket into the
base's upper tab slots, then press down
on the bracket's latches and insert them
into the lower slots.
8
2. Plug one end of the supplied short mod-
3. Insert the supplied AC adapter's barrel
4. Route the adapter and modular cords
5. Plug the modular cord's other end into
jack on the
jack on the back
6. Plug the adapter into a standard AC out-
7. Press and lift out the handset holder.
8. Lift the base's antenna to a vertical posi-
Installation
ular cord into the TEL LINE
back of the base.
plug into the DC IN 9V jack.
through the grooves on the bracket.
the wall plate jack, then align the
bracket's keyhole slots with the wall
plate studs and slide the phone down-
ward to secure it.
let.
Rotate it 180°, then snap it back into
place so it holds the handset.
tion.
jack on the