Storing Your Area Code; Operation; Making And Receiving Calls - Radio Shack 900 MHz Digital Spread Spectrum Dual Keypad Cordless Telephone with Caller ID/Call Waiting ID Owner's Manual
Radioshack sprint 900 mhz digital spread spectrum dual keypad cordless telephone with caller id/call waiting id owner's manual
Table of Contents
Advertisement
43-5520.fm Page 13 Friday, July 21, 2000 8:01 AM
STORING YOUR
AREA CODE
You can store your local area code in the
phone's Caller ID record so it does not show
the area code if the received call is from your
local area. If for some reason you need to
dial the area code (or store it in the memory),
you can add it afterwards. See "Adding/De-
leting the Area Code" on Page 20.
Note: If your calling area requires 10-digit di-
aling including area code, do not enter the
area code but leave this option blank.
Follow these steps to store your area code.
1. Lift the handset and hold down
ˆ
Operation
MAKING AND RECEIVING
CALLS
To make a call, lift the handset and press
.
Talk
and the current volume setting
TALK
(see "Adjusting the Handset Volume") ap-
pear on the handset's display, and the
CHARGE/IN USE indicator on the base
lights. Then dial the number. The number ap-
pears on the handset as you dial, then the
call's elapsed time appears.
You can also dial the number before you
press
.
TALK
If you make a mistake, press
correct entry is erased, then enter the correct
number. To delete the entire number, hold
down
for at least 1 second.
DEL
When you receive a call,
appears. To answer it, lift the handset from
the base and press
TALK
just lift the handset from the base or press
Note: If an area code is already stored, it ap-
pears. To delete the area code, press
three times. Then enter your area code. Or
you can use
edit the area code.
Press
code, then press
set to the base to clear the display.
.
CALL ID
any key.
ting appear.
To end a call, place the handset on the base
or press
Selecting the Channel
The phone has 20 channels. If the call
seems to disconnect for no reason during a
call, press
to select a different channel.
pears while your phone searches for a clear
channel.
until the in-
DEL
Adjusting the Handset Volume
To adjust the handset's volume during a call,
press
desired volume level.
Incoming Call
Volume High
Volume Low
. If auto talk is on,
Operation
2. Press
or
3
VOL/CID
Area Code
.
3. Press
SELECT/CHANNEL
your three-digit area code. If you make a
mistake, repeatedly press
move the cursor over the incorrect digit,
then enter the correct number.
6 6 6 6
7 7 7 7
or
to move the cursor and
SELECT/CHANNEL
CALL ID
Talk
and the current volume set-
.
TALK
SELECT/CHANNEL
8 8 8 8
9 9 9 9
or
until you reach the
VOL/CID
Volume Maximum
,
Volume Medium
appears.
9 9 9 9
twice to select
, then enter
6 6 6 6
7 7 7 7
or
to
DEL
to store the area
or return the hand-
on the handset
ap-
Scanning
,
, or
13
Advertisement
Table of Contents
