Spark Plug - Coleman CK100-S Owner's Manual

SPARK PLUG

This Go Kart comes equipped with
an CHDY - E6TC spark plug.
To inspect the spark plug, remove
the plug cap (1) then remove the
spark plug (2) from the engine with
the spark plug tool provided.
Inspect the plug for carbon deposits
and clean if necessary with a wire
brush. If plug shows excessive
carbon, replace the plug.
CAUTION
Dirt can damage the engine if it
enters the spark plug hole.
Make sure the spark plug hole
is covered after removing plug.
Use a thickness feeler to inspect the
spark plug gap (2). The spark plug
gap should be
0.6 - 0.8mm (0.024 - 0.032 in.)
Re-install the inspected plug or a
new plug until finger tight. Finish
tightening plug with a wrench. If
spark plug is a new plug, tighten
approximately 1/2 turn more with
the wrench. If plug is an old plug,
tighten approximately 1/8 turn more
with a wrench.
MAINTENANCE
0.6 - 0.8 mm
(0.024- 0.032
25
1
CHDY - E6TC
2