Troubleshooting - Merlin Tracer 60 Instruction Manuals

Helpful Information

Troubleshooting

Problem
Unit does not operate
Main motor does not turn
Helicopter will not hover still when
sticks are neutral
Vibration
Replacing the Blades
Your Tracer helicopter may need the blades replacing in the event of a crash. Should you need to replace the blades please follow these simple
steps :-
1. Both the upper and lower blades are fastened with two small screws and can be removed very easily
2. Loosen the screws on the damaged blade and remove them. This will allow you to slide apart the blades to take come off.
3. The lower set will require you to remove the linkage first.
4. Insert the new blades onto the holder pin and replace the screws tightening only sufficient to make sure the threads do not get damaged.
5. Replace the linkage on the lower blade set.
Cause
Transmitter "AA" batteries are depleted or
installed incorrectly, indicated by the battery
icon on transmitter or the low battery alarm.
No electrical connection.
5-in-1 unit not operating correctly
Trimming incorrect
Bent main shaft
Blades are broken
8
Solution
Check polarity installation or replace
with fresh "AA" batteries.
Push connectors together until they
"click."
Consult your retailer
Adjust trim levers
Replace main shaft
Replace blades