Table of Contents
Advertisement
Connect the camera or the speed dome RS485 controller cable to the tester RS485
（2）
interface ,(Note positive and negative connection of the cable).Support RS232 PTZ
controller ,connect the RS232cable to RS232 interface of the tester
3.3
OSD menu
Press the key
2 seconds to turn on
Press the key
2 seconds to turn off
short press the key
to enter sleep mode,press it again to test if tester work abnormally
and cannot be turned off , Press the key
Select Icons to enter, if quit, Please click
page 21
several seconds to turn off, the tester reset
Advertisement
Table of Contents
