CONTENTS • ProMeter Features Prepaid Metering Supply Auto Cut Emergency Credits Dual Supply Meter Over-Load Cutoff Monthly Consumption & Demand Happy Hours / Holidays DG Phase selection Load Survey Maintenance Charge Recharge History • Parts Description • LCD & Keyboard Operation Default Mode Instant Parameter Mode Communication Settings Mode...
Page 4
Precautions • Energy meters are always located in the electrically hazardous areas. To minimize the risk of electric shock it is recommended to avoid any contact with open or loose connections. If any loose wire is observed immediately concern a qualified electrician.
ProMeter Features Prepaid Metering. Prepayment energy meters are a type of domestic energy meter that requires users to pay for energy before using it. Tis is done via a recharge through the supplier vendor. Tey work a bit like a prepaid mobile phones, we have to top-up with balance to get our electricity.
Dual Supply Meter. ProMeter can be used for electricity billing where more than one source of power is available like Generator. Te benefit of dual supply is that different tariff for both the supplies can be programmed separately. Meter automatically detects the supply by sensing the auxiliary terminals available.
DG Phase Selection. Te Meter can be programmed to select any combination of the phases of auxiliary supply to be provided to the customer to facilitate the load management of DG. Load Survey. ProMeter records the daily consumption records of last 6 months for both supplies. Data can be read from the ProMeter using RS485 communication.
Parts Description 1. ProMeter Front Plate. Meter front plate is made from industrial grade plastic mounted on the base of the meter using sealed locks to avoid tampering with. Sticker on the meter front plate can be referred to check the recommended operating condition of the meter. 2.
LCD & Key-Board Operation Default mode. Meter will be in default mode when powered on. It will show following parameters in default mode: 1. Display will show the balance amount remaining in the next screen. balance Press Next Switch to see the balance. 2.
Instant Parameter Mode. Instant parameters such as voltage and current can be viewed at any time by pressing switches Next and Reset at a same time in default mode. Meter will show IN5T PARA. Press next switch to enter instant parameter mode. Display will start in following sequence.
Page 11
Instant Parameter Mode. Instant parameters such as voltage and current can be viewed at any time by pressing switches Next and Reset at a same time in default mode. Meter will show IN5T PARA. Press next switch to enter instant parameter mode. Display will start in following sequence. Press next switch repeatedly to scroll to next display window.
Page 12
5. 62 KW 24. Power in KW. Power b 25. Active Power in Phase B. 5. 75 KW 26. Power in KW. Power t 27. Total Active Power. 5. 75 KW 28. Power in KW. PF R 29. Power Factor R Phase. 1.
Communication Setings Mode. It is possible to change the device ID to be used for communication. Also Baud rate, Parity and stop bits can also be changed from the meter. To change the parameters: ENTER Pa55. 1. Press INC switch for 3 seconds. Display will show 2.
Default Setings. Device ID Baud Rate : 9600 Parity : None Stop Bits Technical Specifcations. Standard : IS135779 Accuracy : Class 1.0 IEC 625053-21 Voltage Rating : 240 V 3P – 4W Current Rating : 10 – 60 Amp Current Withstand : 80 Amp for 1 Sec Starting Current Frequency...
Page 15
OPTIONAL ADD-ON – HOME DISPLAY UNIT Normally meters are mounted either in the basement or in the corridors. Consumers are not able to verify the source of their current supply (EB or DG). Mounted in the house, the display unit forms an interface between them and their respective meters.