USAVision UVS-ABL1300 User Manual page 52

3. You can use the following functions to reduce false alarm.
 Sensitivity: Move the slider to the right to increase detection sensitivity.
 Object Size: When the extent of motion within the detection area exceeds the set
object size, motion detection alarm will be triggered.
[Alarm Parameters]
 Suppress alarm: After an alarm is triggered, the same alarm will not be reported within
the set time.
 Clear alarm: After an alarm is triggered,
 If the same alarm is not triggered within the set time, the alarm will be cleared and
the same alarm can be reported again.
 If the same alarm is triggered within the set time, the alarm will not be cleared until
the suppress alarm time expires. Then the same alarm can be reported again.
[Alarm Triggering Mode]
Upload to FTP: Select to automatically upload snapshots to the specified FTP server

upon motion detection.
 Trigger e-mail: Select to automatically send snapshots to the specified E-mail address
upon motion detection.
 Trigger storage: (The function is only for ADR1300.) Select to automatically start
recording to memory card upon motion detection.
Note:
1. For the Upload to FTP function, make sure to configure the settings in 3.2.4 FTP and
3.3.2 Snapshot first.
2. For the Trigger e-mail function, make sure to configure the settings in 3.2.5 E-mail and
3.3.2 Snapshot first.
3. For the Trigger storage function, make sure to configure the settings in 3.6.1 Storage.
Available from A1 Security Cameras
www.a1securitycameras.com email: sales@a1securitycameras.com