Eyeball dome,
bullet ip camera,
mini fixed rugged ip dome (99 pages)
Summary of Contents for USAVision UA-B580F3
Page 1
Quick Start Guide IP Cameras UA-B580F3 UA-R500F2 UA-R560F2 UA-R580F2 UA-R800F2 Before attempting to connect or operate this product, UVSCAM-UM-C please read these instructions carefully and save this manual for future use.
Page 2
Every effort has been made to ensure that the information in this manual is accurate. USAVision makes no expressed or implied warranty of any kind and assumes no responsibility for errors or omissions. No liability is assumed for incidental or consequential damages arising from the use of the information or products contained herein.
Page 3
Contents 1. Camera Connection Diagram ................1 2. Camera Overview ....................2 3. Installation ......................4...
Page 4
1. Camera Connection Diagram Attention: There are two connection modes: For non-PoE router, please connect the camera by a PoE switch or a PoE injector. For a POE NVR, please connect the camera directly to the POE NVR, then follow the below steps.
Page 5
2. Camera Overview 2.1 UA-R500F2 / UA-R560F2 / UA-R580F2 / UA-R800F2 No. Description No. Description IR LED x 2 (For UA-R500F2 / R560F2 Warm LED x 2 (For UA-R580F2) / R800F2) Built-in microphone (For UA-R500F2 / Default button R560F2 / R800F2) IR LED x 2 (For UA-R580F2) SD card slot Built-in microphone (For UA-R580F2)
Page 6
2.2 UA-B580F3 Description IR LED x 2 Warm LED x 2 Default button SD card slot Note: Press the default button for 15 seconds to reboot the camera.
Page 7
3. Installation Bullet Camera Installation Ceiling Mounting Insert three expansion bolts in place into the ceiling and fix the equipment with three mounting screws. Completion of installation.
Page 8
Dome Camera Installation Ceiling Mounting Paste the sticker in place at the proper position as selected. Remove the collar off the camera by rotating it down.
Page 9
Fix the pedestal by drilling locking holes around the sticker and inserting three expansion bolts into the holes and fastening it with three locking screws. Mount the collar back by rotating it up.
Page 10
Adjust it to an appropriate angle. Completion of installation.