Set Up IR Emitters
Your system may contain third-party products that are
controlled with IR commands (usually through remote
controls). To provide a way for the Home Theater
Controller to control a device that only recognizes IR
commands, complete the following setup.
1.
2.
Use Video Sense Loops
Video sensing can enhance the ability to sense the power
state of a device, such as whether the device is "on" or
"off." If you need to add video signal sensing capabilities
for a video device (such as a TV, VCR, DVD player, etc.),
connect one of the device's composite Video Out ports to
a Home Theater Controller Video Sense In port. Then,
use the companion Video Sense Out port (where
available) for the device's video out as needed.
For Video Sense only (no loop-through), connect a
device's Composite Video Out port to one of the two Video
Sense In ports.
Plug the 3.5 mm connector end of one of the 6 IR
stick-on emitters provided into an IR Out port on the
Home Theater Controller.
Place the stick-on emitter end over the IR receiver on
the media player, TV, or other target device to
transmit IR signals from the Home Theater Controller
to the target.
21