Plan The System Connections - Control 4 AVM-HTC1-B Installation And User Manual

Plan the System Connections

When setting up the Home Theater Controller, you need
to plan the physical connections. Then, at your preference
you can use Interviewer (within Composer) to guide you
through the set up of these connections, or you can set up
the physical connections, and then run Interviewer to tell
the system how things are physically connected.
Complete the worksheet that follows to plan the system
connections. For more information, see the Composer
online help topic "Set up and Design a System with
Interviewer."
Table 2-1. Connection Worksheet for Home Theater Controller
Connection Options and Typical Use
Power plug port—For C6 power
connector. See "Power Up the Home
Theater Controller" for more information.
Ethernet—RJ-45 for a 10/100 BaseT
Ethernet connection. See "Connect to the
Network" for more information.
Video Out Options—Composite or S-
Video port for displaying navigation
menus on a monitor or TV. When
available, use S-Video instead of
Composite for a higher quality display.
Contact (1 set)—Screw-down pluggable
terminal block connector for 1 dry contact
closure, logic input connection, door
contact sensor, or motion sensor. See
"Connect to the Contact Port" for more
information.
14
Reserved for:
1. For C6 power
connector.
1.
1.
1.