Flywheel Installation - Hyundai F4GE9484F*J608 Technical And Repair Manual

22
SECTION 3 - AGRICULTURAL APPLICATION

Flywheel installation

Figure 48 (Demonstration)
1
2
3
- Screw up two hooks or trail rings in the flywheel (1)
threaded ports (4) for handling .
- Using a hoist, handle the flywheel to place it in its housing
inside the flywheel cover box.
- Screw up to pins (2) having appropriate length, in the
shaft ports (3) and using them as guide, assemble the
engine flywheel (1) properly placing it inside the flywheel
cover box.
- Tighten the screws (4) fixing the engine flywheel (3) to
the engine shaft.
Figure 49
Fit tool 99360330 (2) in the starter motor housing to be able
to rotate the flywheel.
Base - February 2009
Figure 50
4
75690
Turn the flywheel until, when pushing the pin 99360616 (1),
it blocks the gear (2).
Figure 51
1
α
2
1
Tighten the engine flywheel (1) fixing screws (2) in two
phases:
88140
- 1st phase; tightening by means of dynamometric wrench
to couple 30 ± 4 Nm;
- 2nd phase, 60º ± 5º angle dwell with tool 99395216.
NOTE Before assembly, always check that the threads of
the ports and of the screws have no evidence of
tear and wear nor dirt.
F4GE N SERIES
84071
75695
Print P2D32N010 E