Hyundai F4GE9484F*J608 Technical And Repair Manual page 50

16
SECTION 3 - AGRICULTURAL APPLICATION
Figure 26
- Remove the engine drive shaft fixing ring from the front
cover. Use the tool 99340055 (4) to operate on the
front tang (2) of the engine drive shaft. Throughout the
tool guide ports, drill the internal holding ring (1) using
Ø 3,5 mm drill for a 5mm depth. Fix the tool to the ring
tightening the 6 screws specially provided.
Proceed withdrawing the ring (1) tightening the screw
(3).
Figure 27
- Using the specially provided tie rod (3) for the tool
99363204 and the lever (4), withdraw the external
holding ring (2) from the front cover (1).
Base - February 2009
Figure 28
- Loosen the screws (1 and 3) and remove the front cover
(2).
78256 NOTE Take note of the screw (1 and 3) assembly position,
since the screws have different length.
Figure 29
- Loosen the screws (1) and remove oil pump (2).
Figure 30
1
2
- Screw out the opposite screws (2) from the ports where
the withdrawal pins shall be introduced (see picture
00904t
following).
- Loosen remaining flywheel fixing screws (1) to the
engine drive shaft.
- Remove the flywheel block tool (2).
F4GE N SERIES
116242
75811
75695
Print P2D32N010 E