Topping Up Washer Fluid - Tesla S 2017 Owner's Manual

Topping Up Washer Fluid

The only reservoir into which you can add fluid
is the washer fluid reservoir located behind
the front trunk. When the level is low, a
message displays on the instrument panel.
Caution: Do not add formulated washer
fluids that contain water repellent or bug
wash. These fluids can cause streaking,
smearing, and squeaking or other noises.
Operate the washers periodically to check that
the nozzles are clear and properly directed.
To top up the washer fluid:
1. Open the hood.
1. Clean around the filler cap before opening
to prevent dirt from entering the reservoir.
2. Open the filler cap.
3. Fill the reservoir until the fluid level is
visible just below the filler neck.
4. Replace the filler cap.
Note: Some national or local regulations
restrict the use of Volatile Organic
Compounds (VOCs). VOCs are commonly
used as antifreeze in washer fluid. Use a
washer fluid with limited VOC content only if it
provides adequate freeze resistance for all
climates in which you drive Model S.
Caution: Under no circumstances do you
need to inspect or top up other fluid
reservoirs. Two additional fluid reservoirs
are located next to the washer fluid, but
underneath the maintenance panel. In the
unlikely event that you see a message on
the instrument panel that one of these
fluid levels is low, stop driving Model S as
soon as safe to do so, and contact Tesla.
Caution: Do not spill washer fluid on
body panels. Doing so can cause damage.
Wipe up spills immediately and wash the
affected area with water.
Maintenance
Fluid Reservoirs
Warning: In temperatures below
40° F (4° C), use a washer fluid with
antifreeze. In cold weather, using a washer
fluid without antifreeze can impair
visibility through the windshield.
Warning: Windshield washer fluid can
irritate eyes and skin. Read and observe
the instructions provided by the washer
fluid manufacturer.
159