Sony DCR-IP7BT Operating Instructions Manual page 19

Registering a Bluetooth device
(6) Select the desired Bluetooth device, then execute it.
The character input screen appears.
<illustration>
(7) Enter the pass key.
For details on how to input characters, see "How to input characters" on page
XX.
E. g., When using the BTA-NW1 Modem Adaptor with Bluetooth Function, the
pass key is its serial number which is indicated on the label on the rear panel.
MODEM ADAPTOR WITH BLUETOOTH
Tip on "Pass key"
The pass key is an identification number needed to allow two Bluetooth
devices to communicate with each other. The connection will be permitted
after entering the pass key. This "Pass key" is also referred to as a "Bluetooth
pass key," "PIN," "Bluetooth PIN," etc. For details, refer to the operating
instructions supplied with the Bluetooth adaptor.
(8) Select [Enter], then execute it.
After the registration is completed, the Bluetooth Setup screen appears again.
The selected Bluetooth device is specified.
<illustration>
Note
When the message "Bluetooth Registration Error Check The Passkey" is
indicated, select [OK], then execute it. Carry out the procedure again from step
4.
(9) Select [Exit], then execute it.
The Setup screen appears again. For details on how to turn off the Modem
Adaptor with Bluetooth Function, refer to the operating instructions supplied
with the Modem Adaptor with Bluetooth Function.
BTA-NW1
® MODEL NO.
TM FUNCTION
Pass key
The number used when registering a
Bluetooth device
19