Related Manuals for Black Box MTU9230
Summary of Contents for Black Box MTU9230
- Page 1 White BLACK BOX ® with 5th black diamond User Manual E3/DS3 Fibre Extender Black Box Network Services 464 Basingstoke Road, Reading, Berkshire, RG2 0BG Tech: 0118 965 6000 | www.blackbox.co.uk...
- Page 2 CONTENTS c i t l i b y t i v i t & 2. 2 Optional rackm 2. 4 Connect the Custom 2. 5 Optionally connec 3.1.4 Unbalanced BNC E3/DS-3 G.703 Customer port & c t i d l i 3.2.4 Scrambler - current version serial no 60128 and above 3.2.5...
- Page 3 1 INTRODUCTION 1.1 About the products The Black Box range of Fibre Converters tabulated below provide a simple economic way of converting from one type of transmission medium to another. Examples include: Electrical signals on copper to optical signals on fibre, and vice-versa.
- Page 4 Introduction The MTU9230/MTU9240 have been designed to be plug and go, conforming to appropriate standards, physically very compact, and rack mountable in sets of 2 using a dual face plate, or 18 units in a rack mount kit for large installations. FC units often enable substantial savings to be made in cable costs by utilising the cheapest effective cable type without incurring the costs of additional router or switch interfaces.
- Page 5 The power consumption of the units is shown below, together with the current consumption over the operating voltage ranges. Product Watts Power 100-250 VAC -36 to -72 VDC -12 to -36 VDC Consumption Current Range Current Range Current range MTU9230 & MTU9240 60 - 25 200 - 100 600-200 power consumption...
- Page 6 Introduction Safety Notes: Excessive voltages are present inside the unit. There are no user serviceable parts inside the unit, and the cover should not be removed by unqualified personnel. The unit must not be exposed to damp or condensing conditions.
- Page 7 The carton should contain a single unit and for UK models, a power cable. If there is any visible damage, do not attempt to connect the device. Contact your Supplier or Black Box Technical support for advice and assistance. 2. 2 Optional rackmounting procedure Rackmounting kit Part No MTU9000M-RACK may be used to mount two FC units side by side in a 19”...
- Page 8 Unpacking & Installation Procedure 2. 3 Power up the units The unit requires 100-250 VAC, 50-60 Hz AC supply, drawing less than 50mA when operating. Alternatively, a -48VDC power supply is available as another option for all models. The DC power options are -36 to -72 VDC (-48VDC), or -12 to -36 VDC (-24VDC), using a Buccaneer type connector.
- Page 9 The units must be connected to safety earth for correct operation. The MTU9230 power supply should be connected to a supply socket that is physically located close to the unit and is easily accessible.
- Page 10 E3/DS3 to Fibre converter 5.1.3 LED Alarms There is a single multi-state alarm LED mounted on the rear panel. Its status options are shown below: LED Status Indication No mains power present Red steady E3/DS-3 Alarm Red/Off flashing E3/DS-3 and Fibre Alarm Green/Off flashing Fibre Alarm Green steady...
- Page 11 Red/Off Flashing Red/Off Flashing Fibre Alarm Fibre Alarm Green/Off Flashing Green/Off Flashing Green steady Status OK Green steady Status OK MTU9230 E3/DS3 - MM MTU9240 E3/DS3 -SM-SH MEDIA CONVERTER (AC) MEDIA CONVERTER (AC) Serial No: Serial No: TEST SCRAMBLER TEST SCRAMBLER...
- Page 12 E3/DS3 to Fibre converter The base panel bit-switches must be set for correct operation as below: 5.2.1 E3/DS-3 This switch is set to specify the Customer side line type. The default setting is E3. 5.2.2 Test Loop This switch initiates an outside test loop on both ports 5.2.3 Line Build out This switch boosts the DS-3 signal strength for long lines of over 255ft.
- Page 13 EN 41003 compliant barrier provided on the E1 interface. Diagnostics Loop Test initiated by Bit-switch MTU9230 Fibre interface G.957, Dual SC Multi-mode 62.5/125 um Bit rate: up to 155.52Mbps Transmit power: -14 to -19 dBm Max Rx input power: -14 dBm...
-
Page 14: Technical Support
White BLACK BOX ® with 5th black diamond Sales Technical Support E-mail Website 0118 965 6000 info@blackbox.co.uk 0118 965 6150 www.blackbox.co.uk...
Need help?
Do you have a question about the MTU9230 and is the answer not in the manual?
Questions and answers