NETGEAR FVM318 Reference Manual page 71

Reference Manual for the Model FVM318 Cable/DSL ProSafe Wireless VPN Security Firewall
Configure the SafeNet software via its Security Policy Editor
3.
Run the SafeNet Security Policy Editor program and, using the
a.
IKE VPN Tunnel Settings Configuration Worksheet" on page
Connection.
• From the Edit menu of the Security Policy Editor, click Add, then Connection. A
"New Connection" listing appears in the list of policies.
• Rename the "New Connection" so that it matches the Connection Name you entered
in the VPN Settings of the FVS318 (A). In this example, it would be
• In the Connection Security box, select Secure.
• In the ID Type menu, select IP Subnet.
• In the Subnet field, type 192.168.3.0 for the network address of the FVS318. In this
example, 192.168.3.0 would be used. The network address is the LAN IP Address of
the FVS318 with 0 as the last number.
• In the Mask field, type 255.255.255.0 as the LAN Subnet Mask of the FVS318
• In the Protocol menu, select All to allow all traffic through the VPN tunnel.
• Check the Connect using Secure Gateway Tunnel checkbox.
• In the ID Type menu below the checkbox, select IP Address.
4-16
Figure 4-13: Security Policy Editor New Connection
"Sample PC to Network
4-12, create a VPN
VPNLANPC.
Virtual Private Networking