NETGEAR FVM318 Reference Manual page 30

Reference Manual for the Model FVM318 Cable/DSL ProSafe Wireless VPN Security Firewall
Now that the Cable or DSL Modem, firewall, and the computer are turned on, verify the
following:
• When power on the firewall was first turned on, the PWR light went on, the TEST light
turned on within a few seconds, and then went off after approximately 10 seconds.
• The firewall's LOCAL LINK/ACT lights are lit for any computers that are connected to it.
• The firewall's INTERNET LINK light is lit, indicating a link has been established to the
cable or DSL modem.
Next, use a browser like Internet Explorer or Netscape to log in to the firewall at its default
c.
address of http://192.168.0.1.
A login window opens as shown in
For security reasons, the firewall has its own user name and password. When prompted,
d.
enter
admin
lower case letters.
Note: The user name and password are not the same as any user name or password you
may use to log in to your Internet connection.
Connecting the Firewall to the Internet
Figure 2-4: Log in to the firewall
Figure 2-5
Figure 2-5: Login window
for the firewall User Name and
below:
for the firewall Password, both in
password
2-7