Section Introduction; Recommended Sequence - Alcatel-Lucent MDR-8000 User Manual

The information contained in this section is a summary of the section
with the same title, but not the same section number, on the enclosed
CD. "Refer to Cd" is used throughout this section to refer the reader to
the detail information on the CD. Go to this section on the CD for inter-
active links to the detail information referred to in this section.
INITIAL TURNUP
4

SECTION INTRODUCTION

4.1
This section describes the procedures required to turn up the MDR-8000 Microwave
Digital Radios after installation.
This provisioning part of the section describes provisioning options available with the
MDR-8000 software application. Provisioning allows for the definition, editing, and storing
of specific functions. The MDR-8000 provides the ability to provision equipment and facili-
ties through a series of Windows™-based screens and messages. The Provisioning menu
lists equipment and functions which may be provisioned. You should use only those provi-
sioning screens that are applicable to your radio.

RECOMMENDED SEQUENCE

4.2
Perform the following initial turnup procedures in sequence:
A.
Install software on PC.
Software installed at the factory before delivery should not be overwrit-
ten by downloading to the radio controller at initial turnup. Refer to
Maintenance section on the attached CD for procedure to upgrade exist-
ing software.
B.
Turn on the radio.
C.
Establish communication between radio and USI computer.
Saving provisioning on disk provides a reference for any future provi-
sioning changes.
D.
Provision radio.
Note
Note
Note
4-1