Installing The Cleaner; Prepare The Pool; Install The Universal Wall Fitting - Polaris 360 Owner's Manual

Installing the Cleaner

Read the complete owner's
manual before you begin installation.
1

Prepare the Pool

1. Turn on the filtration pump for 2-3 minutes to flush out the plumbing lines.
2. Turn off the filtration pump.
3. Lay hose (f) out on the pool deck in sunlight to relax coils. This will reduce
the risk of tangling during cleaning.
2

Install the Universal Wall Fitting

Purpose of installing the UWF
Disconnect can be removed each time without removing the UWF.
1. Remove the Universal Wall Fitting (UWF) (j) from the end of the hose (f) and
thread (by hand) into the dedicated return line opening in the pool.
2. Make sure the filter screen (k) is firmly seated in the Quick Disconnect (i).
3. Install Quick Disconnect into the UWF by turning clockwise (do not over-tighten),
then pull to secure in place.
4
: Once the UWF is properly installed, the Quick
®
j
k
i