Polaris 360 Owner's Manual page 13

Problem
Feed hose becomes tangled.
Sweep hose is sucked into
the vacuum tube.
Sweep hose sprays too much water
The cleaner does not clean the
The cleaner is running in circles on
Solution
1. Remeasure the hose to verify that it is adjusted to the
proper length for the pool shape.
2. With the Polaris cleaner operating, check that the
swivels in the hose and the hose connections turn
freely.
3. Make sure feed hose is floating.
4. With the Polaris
wheels.
All wheels should turn together.
1. Make sure the orifice at the end of the sweep hose is
not blocked by the sweep hose scrubber.
2. Adjust the sweep hose to a gentle sweeping motion.
1. Adjust the speed of the sweep hose by tightening the
out of the pool. adjustment screw.
2. Replace the sweep hose scrubber (part # 9-100-3105)
if it is worn or missing.
3. Add a Polaris TailSweep PRO
accessory to reduce overspray.
1. Check the hose length reaches within 6" of the farthest
entire pool. point of the pool. If not, order a new hose section from
your Polaris dealer.
2. Check thrust jet for 11 o' clock position that optimizes
random turning.
3. With the pump running, turn the cleaner head upside
down. Verify the three vacuum jets have consistent
unobstructed flow. If not, contact Customer Service or
a Polaris authorized Service Center for assistance.
1. Check filter bag, if full it can weigh the cleaner down on
its side.
one side.
2. Remove the head float and shake it. If there is water in
the float, order a new one.
3. The feed hose float should float evenly on the surface
of the pool.
cleaner turned off, spin each of the
®
(part # TSP10)
®
13