Fcc And Ic Regulatory Statements; Power Exposure Information; Federal Communication Commission Interference Statement - Laird BT900-US Integration Manual

BT900-US Hardware Integration Guide
Intelligent BTv4.0 Dual Mode Module
application script. Lower Power consumption may be achieved when all SIO pins are set as
outputs and low (in your
SIO pins are set as output and low.
3 FCC IC R
AND
Model Model
Model Model
BT900-US
PART # PART # PART # PART # FORM FACTOR FORM FACTOR FORM FACTOR FORM FACTOR
BT900-US USB Dongle

3.1 Power Exposure Information

Federal Communication Commission (FCC) Radiation Exposure Statement:
This EUT is in compliance with SAR for general population/uncontrolled exposure limits in ANSI/IEEE
C95.1-1999 and had been tested in accordance with the measurement methods and procedures specified in
OET Bulletin 65 Supplement C.
This transceiver must not be co-located or operating in conjunction with any other antenna, transmitter, or
external amplifiers. Further testing / evaluation of the end product will be required if the OEM's device violates
any of these requirements.
The BT900 is fully approved for mobile and portable applications.
3.2

Federal Communication Commission Interference Statement

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by
one of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
Consult the dealer or an experienced radio/TV technician for help.
FCC Caution: FCC Caution: FCC Caution: FCC Caution:
Any changes or modifications not expressly approved by the party responsible for compliance could void the
user's authority to operate this equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)
This device may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
IMPORTANT NOTE: IMPORTANT NOTE: IMPORTANT NOTE: IMPORTANT NOTE:
Embedded Wireless Solutions Support Embedded Wireless Solutions Support Embedded Wireless Solutions Support Embedded Wireless Solutions Support
Center: Center: http://ews http://ews- - - - support.lairdtech.com support.lairdtech.com
Center: Center: http://ews http://ews support.lairdtech.com support.lairdtech.com
www.lairdtech.com/bluetooth
smart
BASIC application script). In deep sleep 7uA can be achieved if all
S
EGULATORY TATEMENTS
US/FCC US/FCC CANADA/IC CANADA/IC
US/FCC US/FCC CANADA/IC CANADA/IC
SQGBT900US 3147A-BT900US
TX OUTPUT TX OUTPUT TX OUTPUT TX OUTPUT
8 dBm
ANTENNA ANTENNA ANTENNA ANTENNA
Ceramic, Integrated
Laird Technologies
Americas: +1-800-492-2320
Europe: +44-1628-858-940
Hong Kong: +852 2923 0610