Ordering Information; General Comments; Bluetooth Sig Qualification - Laird BT900-US Integration Manual

BT900-US Hardware Integration Guide
Intelligent BTv4.0 Dual Mode Module
5 O I
RDERING NFORMATION
Part N N N N umber Part Part Part umber umber umber
BT900-US

5.1 General Comments

This is a preliminary datasheet. Please check with Laird for the latest information before commencing a design.
If in doubt, ask.
6 B SIG Q
LUETOOTH
The BT900-US module is listed on the Bluetooth SIG website as qualified End Products.
Design Design Design Design
Owner Owner
Owner Owner
Name Name
Name Name
Laird
BT900 Technologie
s
It is a mandatory requirement of the Bluetooth Special Interest Group (SIG) that every product implementing
Bluetooth technology has a Declaration ID. Every Bluetooth design is required to go through the qualification
process, even when referencing a Bluetooth Design that already has its own Declaration ID. The Qualification
Process requires each company to registered as a member of the Bluetooth SIG –
The following link provides a link to the Bluetooth registration page:
https://www.bluetooth.org/login/register/
For each Bluetooth Design it is necessary to purchase a Declaration ID. This can be done before starting the
new qualification, either through invoicing or credit card payment. The fees for the Declaration ID will depend
on your membership status, please refer to the following webpage:
https://www.bluetooth.org/en-us/test-qualification/qualification-overview/fees
For a detailed procedure of how to obtain a new Declaration ID for your design, refer to the following
document: https://www.bluetooth.org/DocMan/handlers/DownloadDoc.ashx?doc_id=283698&vId=317486
To start the listing, go to:
In step 1, select the option, Reference a Qualified Design
You can then select your pre-paid Declaration ID from the drop down menu or go to the Purchase
Declaration ID page.
Note: Note: Unless the Declaration ID is pre-paid or purchased with a credit card, you cannot proceed until the
Note: Note:
SIG invoice is paid.
Once all the relevant sections of step 1 are finished, complete steps 2, 3, and 4 as described in the help
document. Your new Design will be listed on the SIG website and you can print your Certificate and DoC.
For further information please refer to the following training material:
https://www.bluetooth.org/en-us/test-qualification/qualification-overview/listing-process-updates
Embedded Wireless Solutions Support Embedded Wireless Solutions Support Embedded Wireless Solutions Support Embedded Wireless Solutions Support
Center: Center: http://ews http://ews- - - - support.lairdtech.com support.lairdtech.com
Center: Center: http://ews http://ews support.lairdtech.com support.lairdtech.com
www.lairdtech.com/bluetooth
Description Description Description Description
Single Mode Pluggable USB BLE Module featuring
antenna
UALIFICATION
Declaration Declaration Declaration Declaration
ID ID ID ID
D023116 https://www.bluetooth.org/tpg/QLI_viewQDL.cfm?qid=23116
https://www.bluetooth.org/tpg/QLI_SDoc.cfm
Reference a Qualified Design and enter xXXXX in the End Product table entry. Reference a Qualified Design Reference a Qualified Design
smart
L L L L ink to listing on the SIG website ink to listing on the SIG website
ink to listing on the SIG website ink to listing on the SIG website
BASIC – integrated
www.bluetooth.org
Laird Technologies
Americas: +1-800-492-2320
Europe: +44-1628-858-940
Hong Kong: +852 2923 0610