NEC ND-4551 Operating Instructions Manual page 8

Emergency Eject
The procedure described below
can be used to open the tray of
the NEC Writer if the EJECT button
is disabled by software or a power
failure occurs.
1. Turn off the power to the NEC
Writer.
2. If a disc inside still spinning
wait until spin stoped certainly.
3. Insert a steel rod (about 0.8 mm
in diameter) into the emergency
eject hole and push firmly until
the cartridge is ejected. A stiff
paper clip may be used as steel
rod.
14
Driver Installation
The software installation starts
with activating the reading func-
tion of the drive (CD-ROM).
If you are using the NEC Writer
with Windows 95/98/ME/NT/
2000/XP or IBM OS/2 Warp, all
necessary drivers will be loaded
automatically by the operating
20 mm
system.
Drivers mentioned above are part
of the Operating Systems and not
available from NEC.
To use the IDE/ATAPI NEC Writer
with MS-DOS and MS-Windows 3.x,
you have to install the attached
driver software before you can
use the NEC Writer for the first
time.
Refer to the README.TXT file on
the driver disk for information
about installing this driver.
This drive supports RPC according
to SFF8090v4 (RPC-2). The final
setting/definition of the video
region code is determined by the
fifth DVD video region code change.
For Windows 3.xx don't use the
32 bit hard disk access, because
this mode is not supported for
DVD drives.
If the reading function is availa-
ble the next is to achieve the
writing function provided by the
writing software. Please insert
Your writing software CD-ROM
into the NEC Writer and use the
information provided with the
software (if the installation does
not starting automatically you
have to activate the installation
software manually).
Support
For local support like hotline,
service or drivers see the file
„README.TXT" on the software
CD-ROM or NEC´s Internet site
at http://www.neceurope.com
15