LG CodePlus OAT100R Installation & Setup Quick Reference page 9

System Setup (Cont.)
(Continued from previous page)
17. (Optional) If desired, you can identify the location in which the OAT100R is installed.
The location description will be displayed as part of the System Information in the
command line interface and as part of the System Status and Tuner Information
screens in the GUI.
a) If the Command > prompt is on display, type setup and press Enter to access
the Setup Menu.
b) At the Setup Command > prompt, type location and press Enter.
c) At the Enter Location Description: prompt, type a brief description of
the location. Then, press Enter.
d) At the prompt for confirmation, type y and press Enter to set the location. The
system will confirm your update:
Location description has been set.
18. (64-QAM output only) Streams 1, 2, 3, and 4 are confi gured by default when 64-QAM
output is used, though any four of the OAT100R tuners may be mapped to these
streams. In the default system confi guration, Tuner 1 is mapped to Stream 1, Tuner 2
is mapped to Stream 2, etc. If Tuners 5, 6, 7, and/or 8 are among the four tuners that
were connected to the terrestrial antenna distribution system, make sure the tuners
are mapped to the appropriate streams, as follows:
a) If the Command > prompt is on display, type tuner and press Enter to access
the Tuner Menu.
b) At the Enter Tuner number > prompt, type the number of the fi rst OAT100R
RF IN port/tuner to confi gure. Then, press Enter.
The system will identify the current tuner and then display a Tuner Menu command
prompt, for example:
Current Tuner: Tuner-5
c) At the Tuner Command > prompt, type output and press Enter.
d) At the Enter output stream number (1-4 or 0 for no connection >
prompt, either press Enter to accept the default value in square brackets, or type
the appropriate stream number and press Enter to remap the tuner output to a
different stream.
The system will display confi rmation, for example:
Output stream remapped. Tuner is now streaming on output 1.
20
Packet Identifiers (PIDs)
Note: If Pro:Idiom channels are NOT present in the site's entertainment system, PIDs do
not need to be set in the OAT100R, and therefore, you will not need to design a PID map
for the OAT100R output.
Note: See "Packet Identifi ers (PIDs) Overview" in the extended Installation & Setup
Guide for further information on PIDs.
__ Survey the PIDs currently used in the system, and design a PID map for the
__ PIDs must be specified in the OAT100R system as hexadecimal numbers.
Refer to the CodePlus OAT100R Off Air Transcoder System Installation & Setup
Guide for further installation and confi guration information.
Product documentation is available online at: www.LGsolutions.com/products.
(Continued on next page)
206-4219 206-4219
OAT100R output (ensure that up to 64 PIDs are allocated). Ensure that Pro:Idiom
message PIDs are never used by the video/audio PIDs for the OAT100R channels
(or any other system elements).
The program start PID is user-assigned during system setup, and the 63 remaining
PIDs are then automatically assigned within the 64-PID contiguous block.
Setup Information (Cont.)
9