Connecting To The Stackwise Ports - Cisco Catalyst 3850 Hardware Installation Manual

Installing the Switch on a Table or Shelf
Installing the Switch on a Table or Shelf
Procedure
Step 1 To install the switch on a table or shelf, locate the adhesive strip with the rubber feet in the mounting-kit
envelope.
Step 2 Attach the four rubber feet to the four circular etches on the bottom of the chassis.
Step 3 Place the switch on the table or shelf near an AC power source.
Step 4 When you complete the switch installation, see
switch configuration.
After Switch Installation
• Configure the switch by running Express Setup to enter the initial switch configuration. See the switch
• Use the CLI setup program to enter the initial switch configuration.
• Connect to the stack ports.
• Connect to the front-panel ports.

Connecting to the StackWise Ports

Before You Begin
Before connecting the StackWise cables, review the
a Cisco-approved StackWise cable to connect the switches.
Catalyst 3850 Switch Hardware Installation Guide
16
getting started guide on Cisco.com.
After Switch Installation, on page 16
Planning a Switch Data Stack, on page
Switch Installation
for information on
4. Always use
OL-26779-05