Cisco ASR 900 Series Configuration Manual page 9

Command or Action
Example:
Device> enable
Step 2
configure terminal
Example:
Device# configure terminal
Step 3 interface type number [name-tag]
Example:
Device(config)# interface Gigabitethernet
1/0/1
Step 4 cdp enable
Example:
Device(config-if)# cdp enable
Step 5
end
Example:
Device(config-if)# end
Setting the Transmission Timer and Hold Time
Perform this task to set the frequency of Cisco Discovery Protocol transmissions and the hold time for Cisco Discovery Protocol
packets.
Procedure
Command or Action
Step 1 enable
Example:
Device> enable
Purpose
• Enter your password if prompted.
Enters global configuration mode.
Configures the specified interface and places the CLI in interface
configuration mode.
If the encapsulation of an interface is changed, Cisco
Note
Discovery Protocol is reenabled on that interface, even
if Cisco Discovery Protocol was previously disabled.
Enables Cisco Discovery Protocol on the interface.
Returns the CLI to privileged EXEC mode.
Purpose
Enables privileged EXEC mode.
• Enter your password if prompted.
9