Once the unit has received the IP configuration information, it will display it in the
following parameters: DHCP IP, DHCP SM, DHCP GW, DHCP DNS 1, DHCP DNS 2.
7.8.6
E-Mail
The V3 transmitter can send e-mails to provide notifications of alarms or external triggers
becoming active.
Please note that SSL email server authentication is not supported by the unit.
To set up:
1. Enter the email address of the sender in From.
2. Enter the email address(es) of the receiver(s) in Recipient(s). Separate receivers
by commas.
3. For ease of setup, you can choose to send emails via the BW secure server. In this
case, please set Send Via to BW. If you wish to use another server, set this to SMTP.
In this case you will also need to enter the details below in points 4 through 7.
4. Enter the IP address of the SMTP server in Host.
5. Enter the Port number of the SMTP server in Port.
6. Enter the Username for SMTP authentication. If no authentication is required, this
field must be left blank.
7. Enter the Password for the SMTP authentication. If no authentication is required,
this field must be left blank.
8. Set Max emails a day to the maximum number of emails allowed to be sent by
the unit in a single day. Enter the Test folder and set the Recipient(s) for a test
email.
9. Set Test to Yes. Check if the e-mail has been received.