Subaru 2003 LEGACY Service Manual page 62

Transmission section
Hide thumbs Also See for 2003 LEGACY:
Table of Contents

Advertisement

DIAGNOSTIC PROCEDURE WITH DIAGNOSTIC TROUBLE CODE (DTC)
AUTOMATIC TRANSMISSION (DIAGNOSTICS)
1
CHECK HARNESS CONNECTOR BETWEEN
TCM AND TRANSMISSION.
1) Turn ignition switch to OFF.
2) Disconnect connector from TCM and trans-
mission.
3) Measure resistance of harness between
TCM and transmission connector.
Connector & terminal
(B55) No. 18 — (B11) No. 17:
Is the measured value less than the speci-
fied value?
2
CHECK HARNESS CONNECTOR BETWEEN
TCM AND TRANSMISSION.
Measure resistance of harness between TCM
and transmission connector.
Connector & terminal
(B54) No. 10 — (B11) No. 18:
Is the measured value less than the specified
value?
3
CHECK HARNESS CONNECTOR BETWEEN
TCM AND TRANSMISSION.
Measure resistance of harness between TCM
and transmission connector.
Connector & terminal
(B54) No. 10 — Chassis ground:
Does the measured value exceed the specified
value?
4
CHECK HARNESS CONNECTOR BETWEEN
TCM AND TRANSMISSION.
Measure resistance of harness between TCM
and transmission connector.
Connector & terminal
(B55) No. 18 — Chassis ground:
Does the measured value exceed the specified
value?
5
CHECK FRONT VEHICLE SPEED SENSOR.
Measure resistance between transmission
connector receptacle's terminals.
Connector & terminal
(T4) No. 17 — No. 18:
Is the measured value within the specified
range?
6
PREPARE OSCILLOSCOPE.
Do you have oscilloscope?
7
PREPARE SUBARU SELECT MONITOR.
Do you have a Subaru Select Monitor?
Step
Value
1 Ω
1 Ω
1 MΩ
1 MΩ
450 — 650 Ω
Oscilloscope is available.
Subaru Select Monitor is avail-
able.
AT-60
Yes
Go to step 2.
Repair open circuit
in harness
between TCM and
transmission con-
nector.
Go to step 3.
Repair open circuit
in harness
between TCM and
transmission con-
nector, and poor
contact in cou-
pling connector.
Go to step 4.
Repair short circuit
in harness
between TCM and
transmission con-
nector.
Go to step 5.
Repair short circuit
in harness
between TCM and
transmission con-
nector, and poor
contact in cou-
pling connector.
Go to step 6.
Replace front vehi-
cle speed sensor.
<Ref. to AT-54,
Front Vehicle
Speed Sensor.>
Go to step 9.
Go to step 7.
Go to step 10.
Go to step 8.
No

Advertisement

Table of Contents
loading

Table of Contents