Canon Laser Shot LBP5200 User Manual page 351

Data is not printed in the correct color (specified color), or colored text appears blurred due
to color deviation.
Cause 1
Remedy 1 Perform a calibration. (See "Calibrating the Printer," on p. 5-30.)
Remedy 2 Open the [Consumables/Counters] dialog box, and replace the toner cartridge
Cause 2
Remedy
Cause 3
Remedy
The colors of thin lines or filled-in patterns are different from the specified colors, or do not
appear at all.
7
Cause 1
Remedy 1 Adjust the colors in the application and print again.
Remedy 2 Change the patterns with the application and print again.
Cause 2
Remedy
Fill-patterns are not printed in the correct color (specified color).
Cause
Remedy 1 Do not specify a fill-pattern in the application and print again.
Remedy 2 Change the [Color Halftones] setting in the printer driver to [Gradation] or [Color
7-36 Print Quality Problems
One of the four color-cartridges is almost out of toner, or the cartridge has
deteriorated.
that is almost empty with a new cartridge. (See "Replacing Toner Cartridges,"
on p. 5-2.)
Paper is inappropriate.
Replace the paper with paper that can be used with this printer. (See "Paper
Requirements," on p. 2-2.)
Data was sent before completing calibration, such as when the printer was first
turned on.
Make sure that the Ready lamp is on before sending data to the printer.
Some colors cannot be reproduced due to the combination of colors or
patterns.
The color may appear different depending on the fill-pattern.
Readjust to a darker color and print again.
The fill-pattern of the print data and the dither pattern of the printer are
interfering with one another.
Tone].
Specify [Color Halftones] in the [Details Settings] dialog box by clicking [Details]
in the [Quality] sheet.