Alarm - TVR T350 Owner's Handbook Manual

Instrumentation
Alarm System
Alarm & locking
The alarm System installed in your vehicle has been designed to provide optimum
protection at all times. The system uses a contact key and a Rolling code radio key
which never uses the same code twice and is therefore code grabber proof. The
alarm and the immobiliser systems of the car are linked but run on different circuits
to prevent total alarm/immobiliser failure.
Operation of the alarm system
On arming your alarm the immobiliser will instantly activate. 8 seconds after the
ignition is switched off the immobiliser will always arm (even if you do not exit the
vehicle) but the alarm will not arm. If you wish to drive the vehicle then simply press
the button on the radiokey for less than two seconds or insert the contact key, to
switch off the immobiliser.
Locking & using your radiokey
A
Exit the vehicle, press the button on the radiokey (A) once for two seconds, and
release. Your car will acknowledge the signal by flashing its hazards lights twice and
activating the immobiliser. Your alarm is now armed but, an additional 30 seconds
is required for the motion detector to stabilise and become active. A red warning
light mounted in the door mirror adjustment panel (no.8 page 7) will begin to flash
to act as a visual deterrent.
33