Subscribe to Our Youtube Channel
Related Manuals for TVR Cerbera
Summary of Contents for TVR Cerbera
- Page 1 -,t., Service/Worksho p Information In trod uction Hosted and optimised by www.TheTVRSite.com...
-
Page 2: Fuel Handling Precautions
All repairs to the TVR - Cerbera should be carried out Fuel Handling Precautions by a TVR Dealer. Repairs should never be attempted by untrained individuals. - Page 3 5. Do not wash the skin using gasoline, kerosene, diesel before fuel system work commences and it should fuel, petrol, thinners or solvents. always be done by a TVR technician with fuel system Where and when practical, degrease components training.
-
Page 4: Special Note
Airmail, sea, post, passenger train etc. Confirmation orders must be clearly marked to avoid duplication. The dampers have been designed and built for the Cerbera Crates and packing cases used for dispatch goods will be conjunction with an outside specialist. The springs are... -
Page 5: Front Suspension
In an performed more easily and more accurately. ideal world the Cerbera would be aligned at the intended ride height, however, unless it is always to be used with people it will be acceptable to use a passengerless car with at least half a tank of fuel. -
Page 6: General Repair Procedures
Brakes Clutch Mobil Universal Brake and Clutch Fluid SAE J1703 Joints Services by TVR dealers should be carried out at the Mobil Grease Special NLGI Power Steering (where fitted) intervals listed above and everything listed on the ser Mobil ATF vice schedules should be checked. -
Page 7: Engine Oil Filler Cap
CERBERA SERVICE/WORKSHOP .MANUAL - fig 3. Engine Oil Filler Cap NOTE: Do not remove the blue pressure cap on the expansion tank if the engine is hot. Always check the To remove, unscrew the cap in an anti clockwise coolant level when the engine is cold. If for any reason... -
Page 8: Vehicle Identification Numbers
1. Locating The Chassis Number fig 5 7. Brake Fluid Reservoir The Cerbera chassis number is positioned in the engine bay on either the front cross member (early cars) or Check that the fluid level is up to the MAX line on the inside the front wishbone mount. -
Page 9: Jacking Procedure
Jacking Procedure Cerbera, and is only visible when the bonnet is fully open (resting on it's support). The actual position of the plate is at the front of the engine bay on the near... -
Page 10: Transporting By Trailer
- figll When transporting the Cerbera by trailer or by a flat bed transporter etc. it is crucial to secure the Cerbera to the trailer using the correct points on the car. CAUTION: It is essential that jacks and axle stands are positioned under the chassis to avoid damaging the body e.t.c. -
Page 11: Jump-Starting Procedure
If the booster battery is connected to another vehicle start the engine and allow it to idle. Start the engine of the Cerbera using the normal pro - . Jump starting procedure cedure. Remove negative - ) jumper cable. -
Page 12: Cleaning Recommendations
(normally coloured red) to the positive ter minal of the battery (This is the only terminal that is upholstery cleaner may be required to remove ingrained accessible whilst the battery remains in the Cerbera). marks. Leather upholstery will benefit from a periodical application of H.ide Food.
Need help?
Do you have a question about the Cerbera and is the answer not in the manual?
Questions and answers