Adjusting For Application; Wiring The Torqloc (With An Exhaust Brake) - BD Diesel Performance 1030395 Installation Manual

22 September 2015 TorqLoc# 1030395 5

Adjusting For Application

Before installing, open the box up by removing two screws on bottom of module.
On the opposite end of the circuit board from the terminals, there is selection of 8
"dip" switches. These dip-switches control the speed that the TorqLoc module will
disconnect the lock-up clutch. We have provided settings for the module to
disconnect the lock-up at approximately 25mph to 30mph. If you find that the set
speed is too high or low for the vehicle, phone our technical service department for
alternative settings.
NOTE: To ensure proper function of the dip switches, flip each dip switch back and
forth once before setting them, even if the dip switches are already set for the
application it's being installed on.
The "LED" (Light Emitting Diode) on the circuit board will show a Red light when the
TorqLoc is functioning. Once the unit is installed, test drive the vehicle to make
sure the light comes on and then turns off at the set speed.

Wiring the TORQLOC (with an exhaust brake)

Disconnect the ground (Negative) terminals on all vehicle batteries before starting
installation. The following instructions are divided per wire going up to each
individual terminal labeled on the TorqLoc module, and the terminals in these
instructions will be numbered starting from the top at the +12V terminal. Follow
along with the diagrams following the written instructions for ease of installation.
After wiring, additional instructions will follow for 1996-up Dodges. For 1999-03
Ford PowerStrokes, remove the driver's side front fender well for access to
computer harness. When possible, check for continuity through all Posi-Tap™
connectors after you have installed them. We suggest soldering and shrink tubing
all connections, but we also provide Posi-Taps™ for your convenience.
BD Engine Brake Inc.
Plant Address: 33541 MacLure Rd. Abbotsford, BC, Canada V2S 7W2
U.S. Shipping Address: 88-446 Harrison St, Sumas, WA 98295 U.S. Mailing Address: P.O. Box 231, Sumas, WA 98295
Phone: 604-853-6096 | Fax: 604-853-8749 | Internet: www.bd-power.com