Tycon Systems ProWeatherStation TP3000WC Operation Manual page 6

With an open ended paperclip, press and hold the RESET BUTTON for three seconds
to completely discharge the voltage.
If still an issue, remove the batteries from the senor array and cover the solar panel for
at least one minute.
Put batteries back in and resynchronize with display console by powering down and up
the display console with the sensor array about 3 meter away.
6. Best Practices for Wireless Communication
Wireless communication is susceptible to interference, distance, walls and metal barriers.
We recommend the following best practices for trouble free wireless communication.
1. Electro-Magnetic Interference (EMI). Keep the display console several feet away
from computer monitors and TVs.
2. Radio Frequency Interference (RFI). If you have other 433 MHz devices and
communication is intermittent, try turning off these other devices for troubleshooting
purposes. You may need to relocate the transmitters or receivers to avoid intermittent
communication.
3. Line of Sight Rating. This device is rated at 300 feet line of sight (no interference,
barriers or walls) but typically you will get 100 feet maximum under most real-world
installations, which include passing through barriers or walls.
4. Metal Barriers. Radio frequency will not pass through metal barriers such as
aluminum siding. If you have metal siding, align the remote and console through a
window to get a clear line of sight.
The following is a table of reception loss vs. the transmission medium. Each "wall" or
obstruction decreases the transmission range by the factor shown below.
8000060 Rev 1 23-Feb-18
LED light
Figure 6
6
RESET button