Troubleshooting Guide - Tycon Systems ProWeatherStation TP3000WC Operation Manual

Troubleshooting Guide

Installing the wind vane (Note: The sensor array comes fully assembled, these
instructions are only needed if replacing broken parts)
Push the wind vane into the shaft. as shown in figure 1. Make sure the wind vane spins
freely.
Figure 1
3. Installing wind speed cups (Note: The sensor array comes fully assembled, these
instructions are only needed if replacing broken parts)
Push the wind speed into the shaft. as shown in figure 2.
Figure2
8000060 Rev 1 23-Feb-18
24