Tycon Systems ProWeatherStation TP3000WC Operation Manual page 25

Tighten the set screw with as shown in figure 3. Make sure the wind speed cups spins
freely.
Problem
Wireless sensor array (outdoor unit)
not synching to display console.
There are dashes (--) on the display
console for outdoor readings.
8000060 Rev 1 23-Feb-18
Figure3
Solution
Check the outdoor sensor array LED for flashing. It
should flash every 48 seconds. The LED is located
on the bottom of the outdoor sensor array.
If the LED is not flashing every 48 seconds, press
the reset button for 3 seconds then wait at least 3
minutes.
If still an issue, cover the solar panel and remove the
batteries for at least 1 minute, then replace the
batteries. Power down the display console, wait at
least 10 seconds and power it up, then wait at least
3 minutes to let the sensor array sync with the
display console.
How to prevent intermittent wireless
communication issues:
1. Install a fresh set of batteries in the
remote sensor array and console. For
cold weather environments, install
lithium batteries.
2. The maximum line of sight
communication range is 300' but most
users will get 100' or less due to
environmental conditions. Move the
sensor and remote closer together.
3. If the sensor assembly is too close (less
25