Before Operations - JVC EXAD KW-ACX810 Instruction Manual

Before operations

Touch panel
Monitor panel
:
Buttons on the touch panel
In the explanation, they are
indicated inside [ ].
For details on the touch panel
operations, see each source operation
section.
Features of the illumination
Monitor panel buttons
The lights of the monitor panel buttons are turned off
when no operation is done for about 10 seconds.
They are turned on again in the following cases:
– When you touch the touch panel or move your hand
nearby*
– When you use the remote controller
– When a call/SMS comes in (for Bluetooth cellular
phone)
* Depending on the <Illumination> setting. (☞ page
57)
The lights of the monitor panel buttons are always
turned on in the following cases:
– While AV menu screen is displayed.
– While <Source Menu> screen is displayed.
– While <Open/Tilt> menu is displayed.
– When <Illumination> is set to <Normal>.
(☞ page 57)
When you slide
your finger on
the touch panel,
it functions in
the same way as
touching [5 / ∞ / 4 / ¢].
Screen
While the unit is turned on, you can also turn off the
screen by holding DISP on the monitor panel.
The screen is turned on again in the following cases:
– When you touch the touch panel
– When you press MENU, DISP, DETACH, or OPEN on the
monitor panel
– When a call/SMS comes in (for Bluetooth cellular
phone)
– When the signal from the rear view camera comes in
5
[Hold]
INTRODUCTION