X-Press Human Machine Interface; Diagnostic Indication - Datalogic DS5100-X200 Reference Manual

INTRODUCTION

2.3 X-PRESS HUMAN MACHINE INTERFACE

X-PRESS is the intuitive Human Machine Interface
designed with the precise goal of improving ease of
installation and maintenance.
Status and diagnostic information are clearly presented
by means of five-colored LEDs, whereas the single
multi-function key gives immediate access to relevant
functions:

Autosetup to self-optimize reading performance in
demanding applications

Autolearn to self-detect unknown barcodes

Focus Lock to memorize the mechanical focus
position

Test Mode with bar-graph visualization to check
static reading performance
X-PRESS is the common interface adopted in all new products: "You learn one, you can use
them all".
The colors and meaning of the five LEDs when in the one of the operating modes (On-Line,
Automatic or Continuous) are illustrated in par 2.1.1.
NOTE: Except for the Focus Lock/Unlock function, the X-PRESS functions do
not work if the motor or laser are turned off, see chp. 8 for details.

2.3.1 Diagnostic Indication

The "STATUS" and "READY" LEDs blink simultaneously to signal the presence of an alarm
or failure.
Diagnostic messages can be enabled to provide details about specific failure conditions.
These messages will be shown on the display and if enabled for transmission, also on the
selected interfaces. See par. 2.6 for details.
At the same time one or more LEDs light up according to the following scheme:
LED STATUS
READY BLINK
ON to indicate any Failure different than
GOOD
Motor or Laser failures.
TRIGGER ON to indicate a Motor Failure.
COM ON to indicate a Laser Failure.
STATUS BLINK
2
23