Hibernate Mode; Power Options Properties - Dell Latitude D800 User Manual

Power Management
or
Depending on how you set the power management options on the
Properties window, use one of the following methods:
Close the display.
Press
To exit standby mode, press the power button or open the display depending on how you set the options on
Advanced tab. You cannot make the computer exit standby mode by pressing a key or touching the touch
or track stick.

Hibernate Mode

Hibernate mode conserves power by copying system data to a reserved area on the hard drive and then
completely turning off the computer. When the computer exits hibernate mode, it returns to the same
state it was in before entering hibernate mode.
NOTICE: You cannot remove devices or disconnect your computer from a docking device while your
computer is in hibernate mode.
Your computer enters hibernate mode if the battery charge level becomes critically low.
To manually enter hibernate mode:
In Windows XP, click the Start button, click Turn off computer, press and hold
click Hibernate.
In Windows 2000, if
Hibernate, and then click OK.
or
Depending on how you set the power management options on the
Properties window, use one of the following methods to enter hibernate mode:
Close the display.
Press
NOTE: Some PC Cards may not operate correctly after the computer exits hibernate mode.
reinsert the card, or simply restart (reboot) your computer.
To exit hibernate mode, press the power button. The computer may take a short time to exit hibernate mode.
You cannot make the computer exit hibernate mode by pressing a key or touching the touch pad or track
For more information on hibernate mode, see the documentation that came with your operating system.

Power Options Properties

file://C:\temp\~hh1F99.htm
.
hibernate support is enabled, click the Start button, click Shutdown, click
.
Advanced tab in the Power
Advanced tab in the Power
Remove
Page 4 of 6
, and then
2/27/2003