Kelley HK-S User Manual page 29

Dock LeVeLers wiTH aUTo-reTUrn To Dock
oPTion
Do not operate the dock leveler when anyone is on or in
front of it.
Stay clear of the dock leveler when it is moving.
Do not walk on dock leveler or lip until the lip is fully
extended and supported by the vehicle bed.
Never use a fork truck or other material handling
equipment to lower the ramp and lip sections.
1. Do not operate the dock leveler until a vehicle is in
position against the dock bumpers.
2. Tell vehicle driver "your vehicle must stay at the dock."
3. Chock or hitch vehicle.
4. If necessary, remove end loads with the ramp in the
dock level (stored) position. See Fig. 29.
noTe:
If the vehicle to be serviced is below dock level, see operating
instructions for Below Dock Control (BDC) on page 30.
5. To extend the dock leveler lip into the vehicle:
5.1 Turn the "ON/OFF" switch to the "ON" position.
See Fig. 30.
5.2 Push and hold the raise button. The ramp will
rise and the lip will extend once the ramp reaches
the highest position. See Fig. 30.
5.3 Release the raise button once the lip is fully
extended.
5.4 Ramp and lip will lower until the lip rests on the
vehicle bed. See Fig. 31.
6. Proceed with loading or unloading.
March 2014 6004753N — Hydraulic Dock Leveler - One Button Control — Safe
oPeraTion,
Fig. 29
Fig. 30
Lip extend
Vehicle bed
Fig. 31
continued
Dock level
supports
On
Ramp
T
Frame
™
©2014 4Front Engineered Solutions, Inc.
29