Advertisement
● Modeling lamp
Modeling lamp switch (6) decides whether the modeling lamp is on or
off: the switch set left (O position), it's off; the switch set right (I position),
it's on. It turns off automatically when the flash fires.
NOTE: Do not keep long time in using the modeling lamp. It's better to be
cooleddown for 1 minute after 5 minutes continuous use.
● Tube Replacement
Turn down the power before replacing the flash tube and wear insulated
gloves. Then, loosen the iron wire on the tube, keep a balanced hold on the
two feet of the flash tube and pull out the old tube gently. Take down the
feet casing to put it on the new one. Hold two feet of the new tube, and
target directly towards the two copper outlets, then push them slightly in.
Tighten the iron wire to fix the flash tube
● Buzz Function
The device is equipped with buzz function. A "BI" sound will be heard when it
is fully charged and ready to fire.
Technical Data
Model
Flash Output
Guide Number (m ISO 100)
Color Temperature
Power Voltage
Flash Power Control
Modeling Lamp
Recharging Time
Flash Triggering Method
Flash Duration
Fuse
Dimension
Weight
10
120
160
120WS
160WS
38
43
5600 ± 200K
AC110V-120V~60Hz or AC220V-240V~50Hz
stepless
75W
0.5-2 sec
Sync cord, Test button, Slave
1/2000-1/800s
5A
200*190*108mm
Ａｐｐｒｏｘ 0.9KG
Maintenance
● Shut down the device immediately when it works abnormally and find out the
reason.
● Avoid sudden impacts and the lamp should be dedusted usually.
● It's normal for lamp being warm when in use. Avoid continuous flashes
when it is not necessary.
● Except that users can replace the plug-in tube and modeling lamp by
themselves, maintenance of all the flashes is up to our authorized
maintenance department which can provide original accessories.
● Maintenance of all the flashes is up to our authorized maintenance
department which can provide original accessories.
● One year warranty period will be canceled when any unauthorized
maintenance is found.
● If the product had failures or is wetted, it can be continuously used only
after it is repaired by professionals.
● Disconnect the power when doing maintenance work or cleaning.
● New changes made to the specification may not be updated in this
manual.
11
Advertisement
