Getting Started; Detaching The Front Panel; Resetting The Unit; Switching The Fm Tuning Step - Alpine CDE-173EBT Owner's Manual

Getting Started

To cancel the demonstration (DEMO)
display, see page 19.
For the connection/installation, see page
30.

Detaching the Front Panel

You can detach the front panel of this unit to
prevent theft.
1
Press and hold
unit turns off, press the front panel
release button
towards you to remove.
Caution alarm
If you turn the ignition switch to the OFF position
without detaching the front panel, the caution
alarm will sound for a few seconds. The alarm will
only sound if the built-in amplifier is used.
Attaching the front panel
8
-EN
(power) until the
, then pull the panel

Resetting the Unit

Before operating the unit for the first time, or
after replacing the car battery or changing
connections, you must reset the unit.
1
Press and Number button 6 for more
than 2 seconds.
Note
Resetting the unit will erase the clock setting and some
stored contents.

Switching the FM Tuning Step

Set the FM tuning step of your country.
This setting appears only while the source is off
and the clock is displayed.
1
Press and hold
seconds, rotate the control dial to select
[GENERAL], then press it.
2
Rotate the control dial to select [FM
STEP], then press it.
3
Rotate the control dial to select from [FM
STEP 50K] or [FM STEP 100K], then press
it.
4
Press (back) twice.
The setup is complete.

Setting the Clock

1
Press and hold
seconds, rotate the control dial to select
[GENERAL], then press it.
2
Rotate the control dial to select [CLOCK
ADJ], then press it.
The hour indication flashes.
3
Rotate the control dial to adjust the hour
and minute.
To move the digital indication, press
/ .
4
Press ENTER to set the hour and minute.
/SETUP for at least 2
/SETUP for at least 2