Confidence XKCFB-0200 User Manual page 6

1.PREPARATION:
A. Before assembling make sure that you will have enough space around the item.
B. Use the present tooling for assembling.
C. Before assembling please check whether all needed parts are available (at the above
of this instruction sheet you will find an explosion drawing with all single parts (marked
with numbers) which this item consists of.
2.ASSEMBLY INSTRUCTIONS:
FIG.1
PLEASE NOTE :
PEDAL HINGE BOLTS (No15)
Are marked LEFT and RIGHT
the RIGHT bolt tightens CLOCKWISE
the LEFT bolt tightens ANTI CLOCKWISE
ASSEMBLY INSTRUCTIONS:
IMPORTANT
FIG.1:
Attach the Front Stabilizer (NO.7)
and the Rear Stabilizer (N0.2)
with four sets of Carriage Bolts
(NO.4), Washers (NO.6) and
Domed Nuts (NO.5).
N.B. The Front Stabilizer has the
integral transport wheels.
FIG.2:
Insert the Spindle Bar (NO.22)
through the Right Lower Handlebar
(NO.9) and through the main frame,
and, then, through the arc washer
(NO.36) and the Left Handlebar
(NO.10). Put a D Sharp Washer and
a Spring Washer (NO.20 & 21) on
either side of the Spindle Bar and
tighten both ends using the Hinge
Screws (NO.19).
Insert a Pedal Hinge Bolt (NO.15) and
put the arc washer (NO.36) through the
Pedal Post (NO.11 for the right side,
NO.12 for the left). Put a Spring Washer
(NO.18) on the bolt, then pass it
through the Crank (NO.25), and secure
the bolt with an M12 Nut (NO.17).
Repeat this procedure for the left side.
6